Harbor Freight Tools 42203 - Manual (Page 8)

SKU 42203 Page 8
UNPACKING
When unpacking, check to make sure the following parts are included. All sizes listed below are approximate.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual. Refer to parts diagram at end of manual.
Item # Description Qty.
N/A Grinder 1
29 Side Handle 1
28 Wrench 1
2 Grinding Wheel 1
N/A Spare Brushes 2
Warning:
There are certain applications for which this tool was designed. Harbor Freight Tools strongly recommends that this
tool not be modified and/or used for any application other than which it was designed.
All accessories must be rated for at least the RPM speed recommended on the tool’s warning label. Wheels
and other accessories running over rated speed can fly apart and cause injury.
For safest operation, it is recommended that only these accessories be used with this product:
Abrasive Cut-Off Discs and Wheels Flap Wheels
Wire Brushes Wire Wheel Brushes
Always use an approved and proper guard when using the above mentioned accessories. Each accessory
must have the correct arbor size and must fit properly on the shoulder bushing. Make sure accessories are
tightened down securely.
CAUTION: NEVER INSTALL A CARBIDE TIPPED OR STEEL CIRCULAR SAW
BLADE FOR USE ON THIS ANGLE GRINDER. NEVER INSTALL A
WOOD CARVING BLADE, CARVING DISC WITH SAW CHAIN
CUTTERS, OR A CUTTING CARVING DISC ON THIS ANGLE GRINDER.
Rev 03/01
SYMBOLOGY
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
Volts Alternating Current
Amperes
No Load Revolutions
per Minute (RPM)
A
V ~
no xxxx/min.
REV 01/04