Hoover SteamVac Y Series - Manual (Page 12)

12
Clean the nozzle
Clean the brushes
G
D
E
C
F
A
B
Unplug carpet cleaner from electrical outlet.
➤
Remove solution and recovery tanks to prevent possible leaks.
➤
Lift up on top of nozzle (A) and slide off cleaner (Fig. 41).
➤
Wipe debris off nozzle and front of cleaner with a damp cloth.
➤
Tilt cleaner back, raising front of cleaner off floor. Slide nozzle
(B) up from bottom of cleaner (Fig. 42).
➤
Press on upper portion of nozzle to snap in place.
Unplug carpet cleaner from electrical outlet.
➤
Remove solution and recovery tanks to prevent possible leaks.
➤
Tilt cleaner back so handle rests on the floor.
➤
Pull brush assembly firmly to remove (Fig. 43).
➤
Rinse brushes under running water.
➤
Align posts (C) on brush assembly with slots (D) in cleaner
(Fig. 44).
➤
Turn brushes slightly to align square post (E) with square hole
(F) in cleaner (Fig. 44).
➤
Press brush assembly firmly and snap in place.
Unplug carpet cleaner from electrical outlet.
➤
Remove solution and recovery tanks to prevent possible
leaks.
➤
Tilt cleaner back so handle rests on the floor.
➤
Squeeze filter frame (G) and pull it out until it stops (Fig. 45).
➤
Wipe debris off filter.
➤
Slide filter back into place.
Clean the brush filter
41
42
43
44
45
Routine care for your Carpet Cleaner