Hitachi 32UDX10S - Manual (Page 30)

USING THE REMOTE TO CONTROL SATELLITE RECEIVER
FUNCTIONS
30
Operating the precoded function for your satellite receiver.
This remote is designed to operate different types of satellite systems. You must first program the remote to match the remote system
of your satellite receiver. (refer to page 33)
1. Turn ON your satellite receiver.
2. Aim the remote control at the front of your satellite receiver.
3. Press and release the SATELLITE (SAT) button to switch to satellite pre-coded mode.
4. Hold down the SAT button on the remote and enter the two digit preset code that matches your satellite receiver as shown on page
33. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the satellite receiver and press the POWER button. The remote will turn off your satellite receiver when the
correct two digit preset code is entered. When this occurs, the remote control is programmed for your satellite receiver. If the
satellite receiver does not turn off, try a different two digit preset code.
6. The remote will now control your satellite receiver.
NOTES:
1.
If your satellite receiver cannot be operated after
performing the above procedures, your satellite receiver
code has not been precoded into the remote.
2. In the unlikely event that your satellite receiver cannot be
operated after performing the above procedures, please
consult your satellite receiver operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4. The INPUT button will act as the TV/SAT button when in
SAT mode.
ቢ
SATELLITE (SAT) button
This button allows the remote to control your satellite
receiver by setting it to SATELLITE mode.
ባ
PRECODED SATELLITE RECEIVER buttons
These buttons transmit the chosen precoded satellite codes.
ቤ
EXCLUSIVE TV buttons
These buttons are for operating the TV.
POWER
TV
VCR CBL
AV2 AV1
AV3
SAT
DVD
1 2
4 5 6
3
7 8 9
0 LAST CH SLEEP
INPUT
HELP
C.S.
EXIT
MENU
CH VOL
RECALL
MUTE
GUIDE/TV GUIDE/TV GUIDE/TV INFO
VCR PLUS+
SVCS
GUIDE/TV
SCHD
PIP PIP CH
SWAP
FREEZE
PIP MODE
PIP ACCESS
PROG TV/VCR SLOW
SOURCE WIZARD
REC
CLU-577TSI
SELECT
ባ
ባ
ቤ
ባ
ባ ቤ
ቤ
ባ
ቤ
ባ
ቤ
ቢ
C.C ASPECT
MY SATELLITE RECEIVER CODE IS:
NOTE: Refer to instruction manual of the Satellite Receiver for operation of the buttons exclusively for the Satellite Receiver.