Hitachi 32UDX10S - Manual (Page 11)

11
REAR PANEL JACKS
ቢ
Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can
be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a
sub-picture.) The antenna output labeled TO CONVERTER allows the ANT A connection to pass directly to a different source
such as a cable box, only when ANT B is displayed as a main picture.
ባ
Audio/Video Inputs 1 and 2
The INPUT button will step through each video source and antenna source input each time it is pressed. Use the audio and video
inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert
the audio cable into the left audio jack.)
ቤ
MONITOR OUT
These jacks provide fixed audio and video signals which are used for recording. Use the S-VIDEO Output for high quality video
output.
ብ
AUDIO TO HI-FI Output
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be
controlled by the television s main volume.
ቦ
S-VIDEO Inputs 1 and 2
Inputs 1 and 2 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.
ቢ
ባ ቤ
ቦ
P B
P
R
ቧ
ብ
MONITOR
OUT
INPUT 2 INPUT 1
AUDIO
(MONO)
L
R
AUDIO
L
R
S-VIDEO S-VIDEO
VIDEO VIDEO
ANT A
TO
CONVERTER
ANT B
AUDIO
L
R
(MONO)
S-VIDEO
VIDEO Y
AUDIO
TO HI-FI
R L
NOTE: You may use VIDEO, S-VIDEO, or COMPONENT: Y-PBPR inputs to connect to INPUT 1 and 2, but only one of these
inputs may be used at a time.
NOTE: S-VIDEO Output may be used for recording, only when the input is of S-VIDEO type.