Hoshizaki DB-200H User Manual

Page 8

II. INSTALLATION AND OPERATING INSTRUCTIONS

1. CHECKS BEFORE INSTALLATION

IMPORTANT

1. This ice dispensing bin is designed and intended to be used in combination
with a HOSHIZAKI Modular Crescent Ice Cuber, Models KM-280M,
KM-500M, KM-630M, KML-250M, KML-350M, KML-450M, or KML-600M.
The use of this ice dispensing bin in combination with any cuber or flaker,
other than a HOSHIZAKI Crescent Ice Cuber cannot be recommended.

2. Remove shipping carton, tape(s) and packing to prevent damage to the ice
dispensing bin.

3. Ensure all components, fasteners and thumbscrews are securely in place.

1) Remove the Front panel to prevent damage before installing.

2) Remove the package containing the accessories from the storage bin.

3) Remove the protective plastic film from the Side Panels. If the ice dispensing bin has
been exposed to the sunlight or to direct heat, it should be allowed to cool before
removing the protective film.

4) See NAMEPLATE, located on the upper part of the Left Side Panel. Check that the

voltage supplied corresponds with the voltage specified on the NAMEPLATE.