Hoover Encore Canisfer Cleaner with Power Nozzle - Manual (Page 8)

How to use
Power nozzle
The power nozzle adjusts automatically for cleaning hard surface floors and
various heights of carpet. It is not recommended for very irregular surfaces
such as brick, slate, and certain parquet floors unless it is unplugged from
the cleaner. This will stop the agitator from rotating. If desired, the Wall/
Floor Brush (shown in Cleaning Tools section) can be used for this task.
positions
The handle has two positions when
used with the power nozzle:
upright and operating.
To lower handle to operating
position, place your foot on the
power nozzle and push handle
back.
Edge cleaning
Brushed edge cleaning is provided
on both sides of the nozzle to
remove embedded dirt in carpet
near baseboards and furniture.
Guide side of nozzle parallel to
edge of carpet or furniture.
Suction regulator
The suction regulator is located on
the hand grip and is used to
increase or decrease suction for
various cleaning tasks.
If the power nozzle is difficult to
push on some carpet, open the
suction regulator. This will prevent
damage to the belt.
7