Hoover Encore Canisfer Cleaner with Power Nozzle - Manual (Page 6)

How to assemble
Connect hose
Insert hose end with cord into
opening of cleaner, lining up largest
projection on hose with largest
notch of opening. Turn hose to the
right to tighten.
When hose is attached properly,
hose cord plug will reach to
receptacle on cleaner.
Insert plug as deeply into the
receptacle as possible.
To disconnect hose, first remove
hose cord plug from receptacle.
Then, depress latch and turn hose
to the left.
2. Attach power nozzle
and extension wands
Attach wand to power nozzle by
fitting button projection on nozzle
connector into opening in spring
latch. Be sure nozzle is locked in
place.
To release, press down on center
of latch and remove nozzle.
Attach second wand to the first.
Position cord into cord clips on
wands, placing excess cord
between nozzle and bottom cord
clip.
RD PLUG
5