haier HWM60-10 - Manual (Page 15)

13
After switching on, the washing machine reserved wash program will be automatically set
inactive. If you desire a wash cycle to end at a reserved time, you can press the
" " button over 2 seconds to set a delay time wash program.
Refer to The button of " " on page 10.
PROGRAM/DELAY TIME
PROGRAM/DELAY TIME
When "Delay time" becomes active, the nixie tube
displays the time to the end of the delay time wash cycle, and
the indicator turns on.During delay time procedure,push the
"Delay time" button to display the delay time mode.
To change the running program or cancel the delay time,
you should cut off the supply and reselect.
the washing will finish
about 18 hours later
Confirm the delay time program
START
PAUSE
5 Press the "start/pause" button
4 Push the " " button
to select suitable reserve progra m
PROGRA M/DELAY TIME
Close the top lid
Finish washing
Except water filling ,washing,rinsing and draining, if the top
cover is opened, the washing machine will stop running and
alarm.
The washing machine cuts off the power supply
automatically when wash cycle ends.
After switching on the power, press the button "WATER LEVEL" to select a water level according
to the load. Please refer to the button " Water level" on page 10.
Page 10
3 Press the "WATER LEVEL" button to select suitable
water level
WATER LEVEL
START
PAUSE
PROGRAM
DELAY TIME
Page 10