Hyundai DVD Receiver With Bluetooth H-CMD7079 - Manual (Page 4)

4
Installation/Connections
First complete the electrical connections, and then check them for correctness. If you are not confident working
with electrical wiring, removing and reinstalling interior panels, carpeting, dashboards or other components of your
vehicle, please call your dealer in order to have the unit professionally installed.
Before the installation
1. Remove the old unit from the dashboard.
Remove the outer trim frame.
Insert the keys supplied with the old unit into both sides of the unit as shown in figure below until they click.
Pull to remove the old unit from the dashboard. Do not disconnect wires at this time!
2. Mark polarity of the speaker wires.
Marking the polarity of the speaker wires will make it easier to connect the existing speakers to your unit. Consult
wiring diagram of existing head unit before disconnecting any wires. If you are not positive of the polarity of the
existing wires from the speakers to the head unit, install new wires.
While the old unit is playing, disconnect the wires from one speaker.
Take a length of masking tape and fold it around the wire so it forms a flag.
On the masking tape mark the polarity of the speaker wires (+ & -), as well as left or right, and front or rear.
Double check that you marked the first speaker correctly by checking that the speaker wires are the same at the
head unit.
Repeat this procedure for all of the speakers.
Mark the power, ground, and any other wires also.