haier XQBM30-22 - Manual (Page 5)

The largest allowed slope of the shank base of the machine is 2 . The slanting or
rough ground will result in unstable running or stoppage of the machine. Please
adjust it with following methods:
Confirm it's horizontal:
Adjust the adjustable foot:
Hang the lead line to confirm if it is horizontal.
Install the bottom plate
After you open the package, please lean
the washing machine gently down on soft
items ( like the towel cloth, blanket, etc. ).
Install the bottom plate to the bottom of
the machine with the eight screws by
a cross screwdriver, then lift the machine
up gently. See to the figure:
Adjust the installation position
soft items Bottom plate Screw
Loosen Fasten
High Low
adjustable nut
adjustable foot
Before Using Before Using
Introduction of the special functions
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.
Back
Front
1.To twist the adjustable foot, please first
lift up the side of the foot slightly, loosen
the adjustable nut, and twist the foot.
2.Fasten the nut after adjustment.
Hand-wash type wash:
The inner tub and pulsator rotate to opposite
directions during washing to form current like the
hand-wash moving. At the same time the washing
effect is improved significantly because the wall of the
inner tub also acts in washing.