Harbor Freight Tools 92386 - Manual (Page 8)

SKU 92386 for technical questions, please call 1-800-444-3353. Page 8
SpecIfIc SAfeTy ruleS
maintain labels and nameplates on the Tile Saw. These carry important informa-
tion. If unreadable or missing, contact Harbor Freight Tools for a replacement.
use the right product for the right job. There are certain applications for which
this product was designed. Do not use small equipment, tools, or attach-ments to
do the work of larger industrial equipment, tools, or attachments. Do not use this
product for a purpose for which it was not intended.
This product must continuously run with cold water. Dry running will cause
serious damage to the pump seals.
WArNINg! Keeps hands and fingers away from cutting area and Saw blade.
Use a “push stick” (not included) when necessary.
check blade guard for proper forward/backward movement before each use.
Do not operate the Tile Saw if the Blade Guard does not move freely. Make sure
the Blade Guard moves freely and does not touch the Saw Blade or any other part
of the Saw, in all angles and depths of cut.
Do not handle the power Switch with wet hands.
make sure the Tile Saw is located on a flat, level, sturdy surface capable of
supporting the weight of the Saw and work pieces.
Always use Diamond Saw blades with a 7” diameter, 5/8” round arbor hole,
and rated at 3550 rpm or greater.
use the Tile Saw only for cutting ceramic tile, quarry tile, marble, terra-cotta,
and slate with a maximum thickness of 1” if cutting at a 90 degree angle or 1”
if cutting at a 45 degree angle.
Do not use the Tile Saw for cutting metals or for cutting curves. This may
cause the Saw Blade to break and/or reduce it s service life.
make sure the Saw blade is wet at all times when cutting.
Keep all electrical connections dry and off the ground.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
REV 12/06