Hotpoint FFQ50P - Manual (Page 9)

GB
9
Maintenance and care
Switching the appliance off
During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
1. set the FREEZER OPERATION knob on
2. pull the plug out of the socket
! If this procedure is not followed, the alarm may sound.
This alarm does not indicate a malfunction. To restore
normal operation bring the FREEZER OPERATION knob
setting to (off) and turn the appliance on again. To
disconnect the appliance, follow point 1 and 2.
Cleaning the appliance
• The external and internal parts, as well as the rubber
seals may be cleaned using a sponge that has been
soaked in lukewarm water and bicarbonate of soda or
neutral soap. Do not use solvents, abrasive products,
bleach or ammonia.
• The removable accessories may be soaked in warm
water and soap or dishwashing liquid. Rinse and dry
them carefully.
• The back of the appliance may collect dust which can
be removed by delicately using the hose of a vacuum
cleaner set on medium power. The appliance must be
switched off and the plug must be pulled out before
cleaning the appliance.
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic materials
which are odour free. In order to maintain an odour free
refrigerator and to prevent the formation of stains, food
must always be covered or sealed properly.
• If you want to switch the appliance off for an extended
period of time, clean the inside and leave the doors
open.
Replacing the light bulb
To replace the light bulb in the refrigerator compartment,
pull out the plug from the electrical socket. Follow the
instructions below.
Access the light bulb by removing
the cover as indicated in the
diagram.
Replace it with a similar light bulb
within the power range indicated
on the cover (10 W).
Replacing the l Odour filter
The filter should be replaced after approximately 6-8 months
from when it is activated. This period may vary depending on
the type of food that is stored. For information on where a
replacement filter may be purchased, contact Assistance (see
Assistance). To replace the filter, follow the instructions (see
diagrams A and B).
Replacing the Aqua Care filter
The Aqua Care system is fitted with an internal meter
which guarantees filtering safety. The filter is guaranteed
for a maximum volume of 1500 l of water, although this
may vary according to the condition and pressure of the
water supply. Once this limit has been reached, the water
supply will stop, the corresponding alarms are activated
(see Troubleshooting) and the filter must be replaced.
! The filter must always be replaced 6 months after it has
been installed.
! If the filter is replaced before the exhausted filter alarm
indicates the necessity, press the AQUA CARE button for
approximately ten seconds before performing the
replacement.
Replacing the filter:
1. Deactivate the Aqua Care function (see Control panel)
2. Unscrew the filter, turning it in an anticlockwise
direction (1/4 turn)
3. After removing the red cap, screw on the new filter by
turning it in a clockwise direction (1/4 turn)
4. Press the AQUA CARE button for approximately five
seconds if the filter alarm has activated (see
Troubleshooting)
5. Activate the Aqua Care function (see Control panel)
B A
90˚
90˚