Hoover SpinScrub - Manual (Page 12)

3-13
3-14 3-15
After using tool
1. Follow steps a and b for “After clean-
ing” on pages 9 & 10.
2. Rinse tool and hose by filling sink with
a small amount of water. Turn
deep cleaner ON and pickup the water
with the tool.
3. Drain hose by turning deep cleaner
ON and holding end of hose up for sev-
eral seconds. Do not press trigger.
4. Disconnect deep cleaner from electri-
cal outlet.
5. Drain solution tube (located inside
hose) by pointing end of hose in sink
and pressing trigger.
6. Proceed with steps c, d, and e, for
“After cleaning” on pages 9 & 10.
Cleaning carpeted
stairs
Read “Before you begin cleaning”
instructions on page 9.
1. Place handle in upright position.
Agitator brushes will not rotate while
handle is in upright position.
2. Fill clean solution tank with HOOVER
Carpet/Upholstery Detergent according
to instructions for Figs. 2-9 to 2-15.
3. Attach tool to end of hose.
4. Hose length may require that machine
be placed at the top of the stairs to
clean upper half of stairway and at bot-
tom of stairs to clean lower half.
To prevent machine from falling, use
extra caution when cleaning on stairs.
Do not place deep cleaner on stairs.
Do not point tools toward people or
pets.
5. Dry hands and plug deep cleaner into
a
properly grounded outlet.
6. Turn deep cleaner ON. If necessary,
refer to “Before using tool” section to
remove air from the system.
7. Pre-spray the carpeted stair by hold-
ing the tool (A) or (B) about one inch
above the carpet and push it forward
while pressing the trigger (equals one
wet stroke).
8. Position tool against the riser and slightly
p ress it into carpet pile. Press the trigger and
pull the tool
s l ow ly over the carpet (second
wet stroke). Release trigger at end of stroke.
After using scrub tool
To clean scrub pad, pull it off module.
Wash it in water with mild detergent.
Rinse and let air dry.
Pad must be completely dry before reat-
taching to module and storing on deep
cleaner.
Replacement pads may also be pur-
chased. Ask for
HOOVER part no.
40308001.
To store scub module , remove scrub
module from tool in same manner as
removing the brush module.
Align openings on back of module with
tabs in storage area (G).
Push module into position.
3-12
12
G
A
B
3-11
Using the scrub tool
With a little solution, test the scrub
tool on a hidden area before using on
the desired surface. If no surface
change is visible, continue to use as
described below.
1. Fill clean solution tank with HOOVER
Bare Floor Cleaner according to instruc-
tions for Figs. 2-9 to 2-15.
2. Hold scrub tool above area to be
cleaned and press trigger to dispense
solution.
3. Release trigger and scrub area with
tool. Pick up dirty solution with
squeegee as shown.