Heath Zenith Wireless Chime 598-1172-04 - Manual (Page 6)

-6- 598-1172-04
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
3. To change the code, either:
• Add a jumper to the same location on both the push button and the chime or...
• Remove a jumper from the same location on both the push button and the chime or...
• Move a jumper on the push button from one location to another. Move the corresponding
jumper on the chime to match the new location in the push button.
Example: Move jumper at location “5” to location “4” on both the push button and the
chime.
Note: Code positions 1 through 7 must be exactly the same for both the push button and
chime for this system to function.
Note: Unit will come factory set with jumpers in locations 5, 6, and 7 on the push button and
on the chime (see Figure 10).
The range of the wireless chime can vary with location, temperature, and battery condition.
Figure 10
TYPE “D”
TYPE “D”
TYPE “D”
1
2
3
4
5
6
7
8
VOLUME
1
2
3
4
5
6
7
8
Inside Push Button
Front of Chime Base
* Code Settings 1-7
Must Match Both Push
Button and Chime