HONDA WMP20X - Manual (Page 6)

6
STARTING THE ENGINE
1. Turn the fuel valve to
the ON position.
2. Move the choke lever
to the CLOSED
position.
Do not use the choke
if the engine is warm
or the ambient
temperature is high.
3. Turn the ignition
switch to the ON
position.
4. Move the throttle
lever slightly to the
left.
5. Pull the starter grip
lightly until resistance
is felt, then pull it
briskly.
NOTICE
Return the starter grip
slowly back to the engine to prevent damage to the starter.
6. As the engine warms
up, gradually move
the choke lever to the
OPEN position.
7. Set the throttle to the
desired speed to
produce the best
pumping conditions.
Pump output can be
controlled by adjusting
the throttle lever to the
desired position.
At FULL throttle
position, the pump will
deliver the highest
output volume. Moving the throttle toward the IDLE position will
decrease the output volume of the pump.
STOPPING THE ENGINE
Emergency
To stop the engine in an
emergency, turn the
ignition switch to the OFF
position.
Normal
1. Move the throttle lever
fully to the right to the
IDLE position.
2. Turn the ignition switch
to the OFF position.
3. Turn the fuel valve to the
OFF position.
4. If the pump is not going
to be used again for the
rest of the day, or is
going to be stored for a
long period of time, refer
to page 13 for
procedures on properly
storing your pump.
After each use, drain the
pump chamber and flush
with fresh water.
FUEL VALVE
ON
CHOKE LEVER
CLOSED
ON
IGNITION
SWITCH
THROTTLE LEVER
CHOKE LEVER
OPEN
THROTTLE LEVER
FULL
IDLE
IGNITION
SWITCH
OFF
THROTTLE LEVER
IDLE
FUEL VALVE
OFF
POM50594-G_WMP20X.fm Page 6 Tuesday, March 25, 2008 2:34 PM