Hearth and Home Technologies NOVUS GNBC33 - Manual (Page 15)

12-02 15 34615 Rev G
NOVUS B-VENT INSTALLATION INSTRUCTIONS
I. DETERMINING THE IGNITION TYPE
Figure 24 - Standing Pilot Ignition
To determine whether your appliance is an intermittent pilot
ignition or a standing pilot ignition, open the control access
panel (Figure 23) to examine the wiring system. If your system
has a red ignitor button, as shown in Figure 24, you own a
standing pilot ignition appliance. If no red ignitor button is
present, you own an intermittent pilot ignition appliance.
You may also check the rating label located on the inside of
the control access panel to determine ignition type.
Figure 22
Placing the Vermiculite, Lava Rock and Rock Wool
(logs removed for clarity)
Figure 21b - Log Set for NOVUS
5. APPLIANCE PREPARATION
a. Log Set
Remove the two shipping bands from the log set
(Figure 21a) and reassemble. The log set should
look similar to that in Figure 21b.
WARNING - RISK OF CARBON MONOXIDE!
Do not hit or strike glass. Do not operate this appli-
ance with the glass removed, broken or not sealed.
c. Placing the Rock Wool
Place a small amount of 1/2” diameter pieces (dime-
size) of rock wool on the burner pan so that the
rock wool touches but does not cover the holes in
the burner pan. This will provide the “glowing
embers” look. See Figure 22.
6. GLASS AND SCREEN REPLACEMENT
See page 21 of this instruction manual.
7. CONTROL ACCESS PANEL REPLACEMENT
Place the control access panel as shown in Figure 23.
b. Placing the Lava Rock and Vermiculite
See Figure 22 for lava rock and vermiculite
placement.
Figure 23 - Replacing the Control Access Panel
Figure 21a - Log Set for NOVUS