Husqvarna 1030 BioClip - Manual (Page 26)

24
– English
Checking and adjustment of the cutting
unit’s ground pressure
To achieve the best cutting results the cutting unit
should follow the underlying surface without
pressing too hard against it.
The pressure is adjusted with a screw on each side
of the machine.
Adjusting of the cutting unit’s ground pressure is
conducted as follows:
1. Place a set of bathroom scales under the cutting
unit’s frame (front edge) so that it rests on the
scales. If necessary a block can be placed
between the frame and scales so that the sup-
port wheels do not bear any weight.
2. Adjust the unit’s ground pressure by screwing in
or out the adjusting screws located behind the
front wheels on both sides.
The ground pressure should be between 12 and
15 kg.
MAINTENANCE