Harbor Freight Tools 91523 User Manual
Page 16
SKU 91523
PAGE 16
7.
NOTE: The Generator features a 10 AMP DC Fuse (9) to protect the DC circuit in
case of an overload. Should an overload occur the Fuse will burn out, causing
the Generator to automatically shut down. In this case, refer to Step #1 in this
section. Then, reset the circuitry system by replacing the burnt Fuse with a new
10 AMP DC Fuse. Restart the Generator and continue powering the remaining
tool or equipment. (See Figure H.)
4.
Start and run the Engine as previously discussed in this manual.
5.
When finished using the Generator, turn the Engine Power Switch (2) to its
“OFF” position. Turn the Fuel Valve (40) to its “OFF” position. Then, disconnect
the electrical powered tools’ power cord from the Generator’s DC Terminals (7).
(See Figure H.)
6.
After the Engine and Generator have completely cooled, store the Generator in a
safe, clean, dry location (if not already installed in one).
10 AMP
DC FUSE
(9)
POSITIVE (+) DC TERMINAL (7)
NEGATIVE (-) DC TERMINAL (7)
FIGURE H
3.
If using
only
a 12 volt DC tool or equipment, turn the 110/120 volt AC Circuit
Breaker (5) to its “OFF” position. (See Figure D.)