Husqvarna 226HD75S - Manual (Page 11)

11
English
IF SOMEONE COMES
1. Guard against hazardous situations at all times. Warn
adults to keep pets and children away from the area.
Be careful if you are approached. Injury may result from
flying debris.
2. If someone calls out or otherwise interrupts you while
working, always be sure to turn off the engine before
turning around.
MAINTENANCE
1. In order to maintain your product in proper working
order, perform the maintenance and checking operations
described in the manual at regular intervals.
2. Always be sure to turn off the engine before performing
any maintenance, checking procedures or working on
the machine.
The metallic parts reach high temperatures immediately
after stopping the engine.
3. When replacing the cutting attachment or any other part,
or when replacing the oil or any lubricant, always be sure
to use only Husqvarna products or products which have
been certified by Husqvarna for use with the Husqvarna
product.
4. In the event that any part must be replaced or any
maintenance or repair work not described in this manual
must be performed, please contact a representative from
the store nearest Husqvarna authorized servicing dealer
for assistance.
5. Do not use any accessory or attachment other than those
bearing the Husqvarna mark and recommended for the
unit.
6. Under no circumstances should you ever take apart the
product or alter it in any way. Doing so might result in
the product becoming damaged during operation or the
product becoming unable to operate properly.
HANDLING FUEL
1. The engine of the Husqvarna product is designed to
run on a mixed fuel, which contains highly flammable
gasoline. Never store cans of fuel or refill the tank of the
unit in any place where there is a boiler, stove, wood fire,
electrical sparks, welding sparks, or any other source of
heat or fire which might ignite the fuel.
2. Never smoke while operating the unit or refilling its fuel
tank.
3. When refilling the tank, always turn off the engine and
allow it to cool down. Take a careful look around to make
sure that there are no sparks or open flames anywhere
nearby before refueling.
4. Wipe spilled fuel completely using a dry rag if any fuel
spillage occurs during refueling.
5. After refueling, screw the fuel cap back tightly onto the
fuel tank and then carry the unit to a spot 3 m or more
away from where it was refueled before turning on the
engine.
6. Do not inhale fuel fumes as they are toxic.
TRANSPORTATION
1. When hand-carrying the product, cover over the cutting
part if necessary, lift up the product and carry it paying
attention to the blade.
2. Never transport the product over rough roads over long
distances by vehicle without removing all fuel from
the fuel tank. If doing so, fuel might leak from the tank
during transport.
For safe operation
WARNING