Harbor Freight Tools 93722 User Manual

Page 9

SKU 93722

For technical questions please call 1-800-444-3353

Page 9

Position the drill bit at the place to be drilled and squeeze the Trigger. The tool

is variable speed, and will rotate and hammer faster as the Trigger is
progressively squeezed.

When the forward end of the Depth Gauge Rod contacts the work surface, you

know the hole is the desired depth. Release the Trigger to stop the operation
of the tool, and withdraw the bit from the hole.

For Use as a Drill:

Move the Selector Switch to the Drill setting. Please see picture below for

reference. This setting will allow the drill to turn but not hammer.

Select and install an appropriate drill bit. Follow the instructions on page 7 for

installing an SDS-plus drill bit.

Start the drill by squeezing the trigger to be sure that the drill bit is properly

centered in the Chuck. Always use 2 hands when using this tool.

Position the drill bit at the appropriate point on the workpiece and squeeze the

trigger to start the drill operating. The tool is variable speed, and will rotate
faster as the Trigger is progressively squeezed.

When the desired depth has been reached, release the Trigger to stop the

operation of the tool, and withdraw the bit from the hole.

NOTE: This tool is reversible. If the

drill bit does not withdraw easily
from the hole, you may reverse the
rotation to help it come out. With
the tool stopped, move the Forward-
Reverse Switch from right to left.
Then squeeze the trigger, the drill
will operate in reverse. As needed,
stop the operation of the tool, and
press the Forward-Reverse Switch
from left to right to reset the drill in
forward rotation position. CAUTION:
Do not press the Forward-Reverse
Switch while the tool is operating.
This might damage the tool.

The Hammer Drill Selector Switch

Hammer Only

Hammer Drill

Drill Only