Harbor Freight Tools 93722 - Manual (Page 6)

SKU 93722 For technical questions please call 1-800-444-3353 Page 6
Working with the Rechargeable Battery
Charging the Battery:
1. Batteries are normally shipped with low or no charge to prevent potential
problems during shipment. Before use, you must charge your new Battery.
Initial charge time is approximately 1 hour. Subsequent recharge time is
approximately 1 hour.
2. Plug the battery charger into a 120 VAC, 60 Hz power outlet.
3. Insert the Battery into the charger by aligning the rib on the Battery with the
groove in the charger. Press the Battery into place. The Red LED will
illuminate indicating that a Battery is charging.
4. NOTE: During recharging, the Battery will become slightly warm to the touch.
This is normal and not a cause for concern. Do not keep the Battery or
charger in an environment of extreme heat or cold. They will work best at room
temperature.
5. The Red LED will remain on for approximately 1 hour while the Battery
charges. When the Battery is fully charged the charger will stop charging, the
Red LED will go out, and the Green LED will illuminate indicating that the
Battery is fully charged.
6. When the Battery is fully charged, remove the charged battery from the
charger, and unplug the charger
from its power source. Put the
charger away for safekeeping. Do
not leave the Battery in the
charger indefinitely.
Installing the Battery
1. Slide the Battery into the base of
the handle. CAUTION: Do not
press the battery into the handle if
it is not properly aligned, as this
may damage the body of the tool,
and will not secure the battery.
2. Be sure the Battery is properly
installed before using the tool.
Installing the Battery Pack