Hotpoint WM82 - Manual (Page 9)

Button Selection
To select, press button and a coloured band will become visible
(Fig 1). Press again to cancel.
Interlocking Door &
Release Lever
To Open...
Grip the door release lever and pull open the door (Fig 2).
To Close...
Apply pressure at the 3 o’clock position (Fig 3) until the door
clicks.
Indicator Light...
When switched on the door will lock and after a few seconds
the indicator light will illuminate throughout the programme.
Approximately 1-2 minutes after the programme has finished
the indicator light will go out and the door can be opened.
WARNING: Do not attempt to open the door whilst the
indicator light is on.
Wash Dial & Symbols
Before selecting a programme, ensure the mains button is in the
‘OFF’ position. Turn dial slowly clockwise. You will hear a click as
the pointer aligns with the start of your chosen wash
programme, final rinse or spin.
Note: Failure to correctly align pointer at the start of a wash
programme will result in detergent not being dispensed.
2 5
6
3
Start of Wash, Final Rinse
& Spin Programmes
Rinses
Short Spin
End of
Programme
Pointer
Letters represent
programme
(see page 11)
Long Spin
Fig 1
Fig 2
Fig 3
9
Variable Spin Speed Control Dial
To reduce the maximum programmed spin speed, turn the dial
before or during a programme.
Note: Spin speed cannot be increased again whilst the
appliance is spinning.
4