Remove transit bracket – Hotpoint WM82 User Manual

Page 5

WARNINGS

●

Before using appliance,

remove transit bracket,

clamp and screws.

Retain parts for future

transportation.

●

Do not remove

concrete weight.

Replace work top lid and 3

screws.

Remove 2 screws and transit

bracket, retain.

Remove 1 screw and clamp,

retain.

From rear of appliance, grip

sides of work top lid, lift, slide

and pull towards you.

Slide and push work top lid into

position.

Remove 3 screws from back of

work top lid, retain.

Fig 1

Locate front edge into console.

Remember you may be

charged for a service call if a

problem with your

appliance is caused by

incorrect installation or

misuse.

2. Remove Transit Bracket...

Your appliance is fitted with an internal bracket (Fig 1) which prevents damage to the

appliance during transit. Remove parts (Fig 2) following the instructions below.

Note: It is normal for the door seal to look creased, it will not affect its use.

Transit Bracket

●

After removing the

packaging from the

machine, ensure that

the polystyrene

pyramid (shown below)

has come away from the

underside of the

machine, with the

polystyrene base.

If it has not come away,

remove it by tilting the

machine backwards until

the pyramid can be seen

and then remove.

Fig 2