HONDA 08V67-TE0-100A User Manual

Page 11

AII 37561-38377 (0711)

11 of 15

32. Install one wire tie with holder to the back-up sensor

harness 16-pin connector, and attach the wire tie to
the vehicle harness.

33. Mark the inside of the rear bumper:

•

Locate the three marks on the inside of the
bumper at the center and left side.

•

Using a pushpin, pierce the rear bumper at the
top and center of the three marks.

•

Locate the three marks on the inside rear
bumper on the right side.

•

Using a pushpin, pierce the rear bumper at the
bottom and the center of the right mark.

742410BE

VEHICLE

HARNESS

WIRE TIE WITH

HOLDER

BACK-UP SENSOR

HARNESS

6-PIN CONNECTOR

NOTE: There are several markings on the inside of the
rear bumper. Before piercing the rear bumper, verify you
have the correct locations.

742603BE

REAR BUMPER

PUSHPIN

REAR BUMPER

3 MARKS

PUSHPIN

MARK

REAR BUMPER