Hotpoint WMTL80 - Manual (Page 7)

5. Connect to the Water Supply...
● Water inlet: Minimum water pressure: 0.05 MPa or 0.5 bars
Maximum water pressure: 1MPa or 10 bars
● The temperature of the incoming household hot water supply should ideally be 60°C and no
higher than 70°C as this could cause damage to both your laundry and appliance.
● The water supply taps must be easily accessible when the appliance is installed.
● The appliance must be connected to the appliance water supply using the new hose set
supplied, old hose sets should not be used.
WARNING
● Do not connect
appliance to a single
outlet instantaneous
water heater.
Hot and Cold Water Supply
Both hot and cold fill hoses are supplied with your machine - packed in the drum for
transit:
1. Connect the angled end of the RED marked hose to the RED plastic inlet valve at the
back of the appliance. Connect the straight end to your HOT water supply.
2. Repeat the procedure connecting the angled end of hose without a mark to the
WHITE inlet valve at the back of the appliance and the straight end to your COLD
water supply.
3. Hand tighten connectors sufficiently to ensure water does not leak from the hose
connections.
4. Turn on water supply taps and check for leaks from the connectors. In the event of a
leak, turn off supply tap, remove connector and check sealing washer is in place.
Refit connector and tighten. Turn on water supply taps.
7
Remember you may be
charged for a service
call if a problem with
your appliance is
caused by incorrect
installation or misuse.
Cold Water Adaptor
If you have no hot water
supply or your hot water
pressure is low... you can use
a cold fill adaptor.