Hunter Fan 44033-01 44277 - Manual (Page 12)

44033-01 • 05/11/2010
12
• The schedule time can be set in 15 minute increments, and remains the same
for both Heat and Cool programs.
• The scheduled temperature can be set in increments of 1°F (1°C).
• After 15 minutes without a key press, the thermostat will return to the home
display screen and save any changes you have made.
• When setting the schedule time, note the AM / PM indicator.
• At any stage during your scheduling, you can use the
Back
or
Next
buttons to
move forward or backwards through the steps.
Done/
Home
will also save any changes,
even if you have not scheduled or altered all settings.
• Arrows beside each schedule mode and beside heat/cool modes will indicate
which is active.
Read the scheduling section thoroughly to ensure you understand your scheduling
options and which will best fit with your lifestyle. The following notes should help
you with scheduling:
5
Scheduling
Scheduling Introduction
This thermostat has been pre-programmed to provide optimal energy savings.
No programming is necessary. We recommend you run these programs for a
few days before adjusting your programming. If it is necessary to change these
settings, use the scheduling table on the next page to record your new settings.
You will also find the default schedule there as well.