Hustler Turf FASTRAK 60 - Manual (Page 35)

602900 4-9 REV F
NOTES:
1. Initial oil change is after 5 hours of operation. Thereafter, change oil after every 40 hours operation. Change more often under dusty or dirty conditions and dur-
ing hot weather priods.
2. Torque initially and after first 2 hours of operation.
3. Change engine oil filter per the engine manufacturer’s recommendations. Refer to Engine Owner’s Manual for recommendations and other maintenance items..
4. Service more often under dusty or dirty conditions.
5. Pump drive belt only - Inspect every 100 hours and replace if worn or cracking is noticed. Otherwise, replace every 200 hours or 2 years whichever comes
first.
6. Check fuel system for any crack or leaks including, but not limit to, fuel line hoses, fuel valve, vent line hoses, vent valve, vapor valve, carbon canister, and
grommets. Repair as needed.
7. Initial system oil and filter change must be after the first 75 hours of use or 1 year whichever comes first. Thereafter, replace filter and oil in each transaxle every
2 years or 200 hours, whichever comes first.
8. More often under dusty or dirty conditions and during hot weather.
9. Inspect ROPS after the first 20 hours of operation and then after every 300 hours of operation or yearly whichever comes first.
REFERENCES:
A. Refer to engine owner’s manual for engine service information.
NOTE: After completing maintenance cycle (300 hours), repeat cycle.
Maintenance Schedule
Figure 4-14, Figure 4-15, Figure 4-16,
Figure 4-17, Figure 4-18, & Figure 4-19
SERVICE AT
INTERVALS INDICATED
WEEKLY
OR 50
HOURS
MONTHLY
OR 100
HOURS
ANNUALLY
OR 300
HOURS
Verify safety start interlock system Prior to each use
Visually inspect unit for loose hardware and/or damaged parts Prior to each use
Visually inspect tires Prior to each use
Check oil level, engine (1) Prior to each use or every 4 hours
Clean air intake screen (4) Prior to each use or every 4 hours
Clean foam element (4) Prior to each use or every 4 hours
Check fuel level Prior to each use
Blades - sharpen & securely fastened Prior to each use
Discharge chute - securely in place & in lowest position Prior to each use
Clean engine and transaxle compartment Daily
Change transaxle oil and filter (7) Every 200 hours or 2 years
Grease deck height pivots X
Grease front wheel bearings X
Change engine oil and filter (1) (3) X
Clean cylinder and head fins (a) X
Check battery connections X
Check tire pressure with a gauge X
Check hydraulic oil level X
Clean engine exterior (a) X
Clean & regap spark plugs (a) X
Check pump and deck belt tension and condition (5) X
Check fuel system (6) X
Check hydraulic lines X
Check fuel valve and grommet (6) X
Tighten lug nuts on wheels (2) X
Change fuel filter (6) X
Replace spark plugs X
Check ROPS mounting hardware (9) X
Replace fuel evaporation system filter (8) X