Hustler Turf FASTRAK 60 - Manual (Page 22)

REV F 3-8 602900
Possible damage to ROPS
If the unit has rolled over or the ROPS has been in some other
type of accident (such as hitting an overhead object during
transport), the ROPS must be replaced to retain the best
protection.
Following an accident, check the ROPS, the operator’s seat,
the seat belt, seat belt mountings and seat latch for possible
damage. Before operating the machine, replace all damaged
parts.
IMPORTANT: Do not attempt to weld or straighten the
ROPS.
ROPS Inspection
Inspect the ROPS after the first 20 hours of operation.
Following the initial inspection, check the ROPS after every 500
hours of operation or every six months, whichever comes first.
1. Check the torque of the ROPS mounting bolts. Tighten
the bolts to the correct torques as shown below if
necessary. Figure 3-8
2. Inspect the operator’s seat and the mounting parts for the
seat belt. Tighten the bolts to the correct torque as shown
below if necessary and replace parts that show wear or
damage.
3. Check the seat latch to make sure it is secured and
functioning properly. Adjust or repair it as necessary.
Torque values are given below:
Ft-lbs. N-m
ROPS mounting bolts . . . . . . . . . . . . . . . . . . . . . . 55 . . . . 75
Seat belt mounting hardware. . . . . . . . . . . . . . . . . 48 . . . . 65
Mower Operation
This mower is equipped with the SmoothTrak™ steering
system. The following provides you with detailed information
on how to operate the mower efficiently.
Driving the mower
After starting engine, engage the steering control levers and
steer as follows:
To go forward, push steering control levers forward an equal
distance (Figure 3-9).
To go in reverse, pull steering control levers rearward an
equal distance (Figure 3-9).
To turn left, move the right steering control lever farther
forward from neutral than the left steering control lever.
To turn right, move the left steering control lever farther
forward from neutral than the right steering control lever.
(Figure 3-9)
Zero radius turn, move one steering control lever forward
and the other steering control lever back of neutral. This will
allow the drive wheels to counter-rotate. (Figure 3-9)
To stop or decrease speed, move steering control levers to
neutral. When going forward pull back gently on steering
control levers. When going in reverse push forward gently on
steering control levers.
WARNING
The ROPS structure’s protective capability may be
impaired by structural damage, overturn or altera-
tion. Do not remove or alter any of the ROPS parts. Do
not attempt to weld or straighten ROPS. Failure to adhere
to these instructions could result in severe injury or death.
If the ROPS or cab is replaced, make sure that the proper
hardware is used and the recommended torque values are
applied to the attaching bolts.
WARNING
Never operate the mower with the seat latch un-installed
and improperly secured. The seat platform must be
securely latched to prevent seat from moving/tilting in the
event of mower tipping or rollover.
Figure 3-8
DANGER
Never make sudden stops or reverse direction, especially
when maneuvering on a slope. The steering is designed
for sensitive response. Rapid movement of the control
levers in either direction could result in a reaction of the
mower that can cause serious injury.
ROPS
mounting
bolts
ROPS post