Hitachi VT-M282A - Manual (Page 26)

Getting Started (Videotapes)
26
Getting Started (Videotapes)
• About Videocassette Tapes
Types
The best thing you can do for your VCR is use the best quality tapes available. This VCR uses
VHS tapes only, which are the most common type. Look for the VHS mark on new or
prerecorded tapes you buy.
Tapes are marked either T-120 or T-160, which signifies how many minutes of programming
they can hold at standard recording speed (SP). To get the best quality picture, record at standard
speed. But if you want to get more on a tape and are less concerned about the quality, set the
VCR for extended play (EP).
Tape Capacities at Different Speeds
TYPES RECORDING TIME
SP EP
T-120 120 min. 360 min.
T-160 160 min. 480 min.
You may have noticed that there is also an LP speed. Your Hitachi VCR does not record at this
speed, but it can play cassettes that were recorded in LP mode. No special setting is required for
playback.
Safety Tabs Prevent Erasure
A safety tab is located on the front left edge of every videotape next to the label. Break this tab
off if you want to keep a special tape from being erased accidentally. (Notice this tab is already
removed on prerecorded tapes you buy or rent.) Insert the tip of a screwdriver or similar kind
into the space behind the tab to break it off.
Don't worry, you can change your mind and record on this tape even after the tab is broken off -
simply cover the hole with cellophane tape.