Hitachi VT-M282A - Manual (Page 14)

Getting Started (Hookups)
14
1. Remove the antenna line from the back of your TV if it is already connected there, or take it
from where it comes in on the wall.
2. Considering the three pictures below, determine which adapter you will need to hook into your
VCR.
If you have Use this adapter
Single 300 ohm flat wire
Separate UHF and VHF antenna
antenna wires, both 300 ohm
flat wire
300 ohm flat UHF and 75 ohm
round VHF
If you have "rabbit ears" (an antenna on top of your TV), you will need an additional adapter and
75 ohm extension to make your leads reach from the antenna to the VCR. This connection will
work only if you have a strong, clear picture on the TV, indicating a strong signal. Connect the
antenna to the adapter, and use the cable extension to go from the adapter to the VCR. Use the
supplied 75 ohm cable to connect the VCR to the TV.