Harbor Freight Tools 2" Gasoline Powered Clear Water Pump 68375 User Manual

Page 7

Page 5

For Pump technical questions, please call 1-800-444-3353.

Item 68375

For Engine technical questions, please call 1-800-520-0882.

The emission control system for this Pump’s Engine is

warranted for standards set by the U.S. Environmental

Protection Agency. For warranty information, refer to the

last pages of this manual.

Connecting Hoses

Note: Hose coupling components

and hoses not included.
Note: The Suction Hose (not included) MUST be

reinforced with braided material or have non-

collapsible construction. Do not use a hose

with an inside diameter smaller than 2″ (pump’s

intake and discharge port diameters).
CAUTION: Do not over-tighten Hose Clamps as the

clamp may damage the hose or other components.

1. Slide one of the Hose Coupling Rings over

one of the Hose Couplers (a), then place a

Gasket on the end of the Hose Coupler (b).

Gasket

Hose Coupler

Hose Coupling Ring

Thread the Hose Coupling Ring onto the Intake Port

(a), and turn clockwise until fastened securely (b).

Intake Port

3. Slide one of the Hose Clamps over the end of the

suction hose (a). Slide the Hose onto the Hose

Coupler (b). Use a screwdriver (not included)

to tighten the Hose Clamp until secure.

CAUTION: Use only a non-collapsible intake hose.

Hose Clamp

Suction Hose

Slide a Hose Clamp over the other end of the suction

hose (a). Slide the Intake Strainer into the end of the

suction hose (b). Use a screwdriver to tighten the Hose

Clamp until secure.

Intake Strainer

Set up