Hotpoint HDA797K - Manual (Page 4)

How to operate your dishwasher
Door Latch Indicator Dial
- (Turn:0 Start)
I
STEP 1. Load your dishwasher
with dishes, silverware, pots,
pans, bowls, etc. according to
instructions on pages 8 and 9.
STEP 2. Add detergent to the
detergent dispenser. Make sure
the Cycle Indicator Dial is at OFF
position before adding detergent.
(See pages 6 and 7.)
Use rinse aid agent to help prevent
spotting. (See page 6.)
STEP 3. Select DRYING HEAT
option. It must be ON for PLATE
WARMER cycle, OFF for
HOLD cycle. It can be ON or OFF,
at your option (see below), for any
of the wash cycles.
DRYING HEAT
ON OFF m
ON. Turns the drying heater on for
fast drying.
OFF. Turns the drying heater off
to save energy. Dishes will dry
naturally over a longer period
such as overnight.
If you need your dishes sooner,
open the dishwasher door after the
cycle is complete to reduce the
natural drying time.
Use of this option reduces the
electrical energy used by this
model approximately 10% for
the NORMAL WASH cycle.
STEP 4. Select the cycle and start
the dishwasher.
If your dishwasher drains into a
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher. (See Cycle
Selection Hints at right.)
To obtain the benefits of a complete
cycle, be careful that you do not
turn the dial any further than
necessary to start the dishwasher.
For & PANS and
NORMAL WASH cycle:
POTS NORMAL
PANS WASH
a. Push selected cycle button.
b. Latch the door.
LIGHTwASH ■
■
~@
■
. RINSE
HOLO
PLATE WARMER
■
c. Slowly turn Cycle Indicator Dial
to ON position to start the cycle.
●
For LIGHT WASH cycle:
a. Be sure door is unlatched.
b. Push NORMAL WASH cycle
button.
I
c. turn Indicator Dial
c. Slowly turn Cycle Indicator Dial
to LIGHT WASH position.
d. Latch door to start the cycle.
●
For RINSE HOLD cycle:
a. Be sure door is unlatched.
b. Select DRYING HEAT-OFF
to RINSE position.
d. Latch the door to start the cycle.
4