Husqvarna 1153183-95 - Manual (Page 39)

English – 39
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
This Husqvarna chain saw model is in the ANSI category of saws above 3,8 cu. in. and is not required to comply with
low kickback performance requirements. However, for this model we recommend the following cutting equipment. The
combinations of power head, bar and chain have been investigated in accordance with the kickback and vibration
requirements of ANSI B 175.1–1991.
Listed ATL is the Oregon designation of Armour Tip Large hard nose bar.
Saw chain filing and file gauges
Bar
Chain
Length, inch Pitch, inch Max. radius nose wheel
24-42 0,404 ATL 1,65” Husqvarna H64, Oregon 27
!
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries
to the user. Do not operate this saw unless you have extraordinary cutting needs and experience
and specialized training for dealing with kickback. Saws with significantly reduced kickback
potential are available. Always use the safest saw and cutting equipment applicable to your cutting
need.