haier WM6002A - Manual (Page 13)

The washing machine can detect the laundries automatically.
After detection,it will set the water level to suitable value among
4, 6, 8and 10 automatically.
You can also set water level by yourself. After the machine is
started, it will not set water level automatically. You shall push
the start/pause button to make new setting.
If there's water inside the tub, the machine cannot detect the
laundries and will display water level 6 .
If wet laundries are put in, it may display water level 10 . You
must set suitable water level by yourself.
If posthaste program is selected, it will display water level 3 .
When water level 2 is reached in water filling, it will perform
washing while filling water.When water level 3 is reached, it
will change to normal washing.
During operation of wash and rinse program, you can push
down the water level button to add water. When you release
the button, or it reaches the overflow water level, the machine
will stop adding water.
The water level decided may be different from actual value
because of the different moisture level of the laundries.
Start/Pause button
“ ••• • • • ••• •• ” button
Push the ON/OFF button to switch on the power.
When the power is on, push it again to switch off
the power.
Push the ON/OFF button to switch on the power.
If the start/pause button is not pushed, the
washing machine will automatically switch off the
power after 5 minutes.
“CHILD LOCK”
function
10
8
6
4
2 9
7
5
3
1
Push and hold the water level button and spin button, then push down
the power on/off button. The digitron displays CL . You can continue
setting desired washing procedures. After setting, push down the
start/pause button. The child lock function is activated. All of the buttons
are locked and cannot make selection.
Release the child lock function: push down the water level and spin button
at the same time for more than 1 second. After a beepsound, the child lock
function is released.
+
WM6002A
During sensing, it displays --
During reserve procedure, it displays the remained reserve time (in hours)
During operation of programs, it displays the remained time (minutes).
If the remained time exceeds 99 minutes, it adopts A at tens place to
represent 100 minutes, b to represent 110 minutes. For instance, A3
represents103 minutes.
In case of abnormal phenomenon, it displays
the abnormal symbol (see to Page 16)
Page16
START
PAUSE
POWER
ON/OFF
RESERVE
WATER
LEVEL
PROGRAM
FIBRE
COTTO
N
WOOLLEN
SILK
NORMAL
QUICK
POSTHASTE
JEAN
CHILD LOCK
In normal operation mode, the reserve indicator light is off. The time
remain indicator light is on. The digitron displays the time remained
(in minute) before the washing is finished.
Push down the reserve button. The reserve indicator light is on
the digitron displays the reserve time of finishing washing (in hour).
When the machine is started, the reserve indicator light is on,
indicatingthat the reserve function is running.
After the power is switched on, push it to
Start the machine
During working, push it to pause working.
During pause, push it to resume working.
“•••••••” button
“••••• •••••” button
“•••••••” selection button
Following automatic programs are available for selection
PROGRAM Applicable situation
NORMAL Common washing
QUICK Quick and high-efficiency wash for common laundries
POSTHASTE Super quick wash of the laundry under 1 kg with light soil
JEAN Washing the relatively big and thick laundriesr
FIBRE Washing the chemical fiber laundries
COTTON
WOOLLEN
SILK
Washing the cotton textiles
Washing the woollen textiles
Washing the silk textile
Reserve/remain time indicator digitron
Time remianed
(minutes)
Reserve
(hours later)