Float unit and foam filter, Motor protection filter, Double-injection nozzle – Philips HR6835 User Manual

Page 14: Shampoo pump, Storage, Replacement, Dustbag, Paper dustbag (specific types only)

reusable dustbag (specific types only)

If you use the reusable dustbag, clean the Motor Protection Filter once a year in lukewarm water.
Make sure the filter is completely dry before you reinsert it into the vacuum cleaner.

Float unit and foam filter

Rinse the float unit and the foam filter. (Fig. 47)

To guarantee an optimal lifetime for the foam filter, carefully remove it from the float unit.

(Fig. 48)

Clean the filter separately. (Fig. 49)

Squeeze the foam filter to remove excess water. Do not wring it!

Motor Protection Filter

The Motor Protection Filter can also be removed for cleaning. (Fig. 50)

Rinse the Motor Protection Filter under the tap. (Fig. 51)

Do not forget to put the Motor Protection Filter back into place.

Double-injection nozzle

Rinse the double-injection nozzle under the tap. (Fig. 52)

Remove the hard floor adapter and clean it separately. (Fig. 41)

Fill the container with lukewarm fresh water. Pump out the water through the two shampoo

hoses into a sink or toilet. This prevents shampoo residues from caking the inside of the

hoses and clogging them up.
shampoo pump

To extend the lifetime of the shampoo pump, clean it with a mixture of water and white vinegar

once a year.

Pour 1 litre of white vinegar into the shampoo reservoir and top it up with lukewarm fresh

water.

Let the appliance run in shampooing mode until the shampoo reservoir is empty. Collect the

vinegar solution in a bucket.

Repeat this procedure with 1 litre of fresh water to rinse out any vinegar residues.

storage

Switch off the appliance and remove the mains plug from the wall socket.

Press the cord rewind button. (Fig. 53)

The mains cord is wound up automatically inside the appliance.

Note:When the shampoo reservoir is attached to the appliance, the mains cord does not disappear

completely into the appliance when the cord rewind button is pressed.

Store the small nozzles in the way that is shown in the figure. (Fig. 54)

Specific types only: to park the tube, insert the parking clip into the parking slot on the side

of the appliance. (Fig. 55)

Note:To avoid accidental damage to the appliance, the parking clip comes off the tube or the appliance

when the tube is pulled or knocked fiercely. You can simply snap the parking clip back onto the tube

when this happens.

English

This manual is related to the following products:

HR6836