Philips HR6835 - Manual (Page 8)

8
general description (Fig. 1)
A Dry use
1 Hose connector
2 Suction hose
3 Mechanical suction power control
4 Suction tube
5 Tri-Scopic tube (specific types only)
6 Parking clip (specific types only)
7 Nozzle
8 Motor on/off button
9 Handle
10 Cord rewind button
11 Micro Filter (specific types only)
12 Mains cord
13 Parking slot
14 Clamps
15 Motor unit
16 Type plate
17 Dustbag holder
18 Dustbag
19 Container
20 Storage facility for 2 small accessories (small brush, small nozzle, crevice nozzle or flexible
crevice nozzle)
B Wet use
1 Shampoo hose clips
2 Shampoo trigger
3 Shampoo hoses
4 Shampoo hose connectors
5 Shampoo reservoir
6 Shampoo pump on/off button with light
7 Diffuser
8 Motor Protection Filter
9 Philips cleaning liquid HR6965
10 Float unit with foam filter
11 Upholstery nozzle
12 Double-injection shampoo nozzle
13 Hard floor adapter
important
Read these instructions for use carefully before you use the appliance and save them for future
reference.
Check if the voltage indicated on the type plate corresponds to the local mains voltage before
you connect the appliance. You can find the type plate on the bottom of the motor unit.
Do not use the appliance if the plug, the cord or the appliance itself is damaged.
If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid a hazard.
Always remove the Micro Filter and the paper or reusable dustbag before wet use.
Always install the diffuser and the float unit before you use the appliance to vacuum liquids.
Do not insert the mains plug into the wall socket until the appliance is completely ready for
use. Make sure that your hands and the mains plug are dry when you connect or disconnect
the appliance.
,
,
,
,
,
,
English