Specifications, Unpacking, Instructions for putting into use – Harbor Freight Tools 95082 User Manual

Page 8

SKU 95082

For technical questions, please call 1-800-444-3353.

Page 8

SPEciFicAtiONS

Electrical Requirements 120 V~ / 60 Hz / 11.8 A
Motor (Cutter head)

Speed

2-1/2 HP, 18,800 cuts

per minute

Maximum Cutting Depth 3/32”
Stock Capacity

4-1/2” x 12” lumber

Feed Speed

20 Feet per Minute

Included

Accessories

1 Hex Wrench (4mm)

2 Magnets

uNPAcKiNg

When unpacking, check to make sure

item is intact and undamaged. If any parts

are missing or broken, please call Harbor

Freight Tools at the number shown on the

cover of this manual as soon as possible.

iNStRuctiONS FOR

PuttiNg iNtO uSE

Read the ENtiRE imPORtANt

SAFEtY iNFORmAtiON

section at the beginning of this

manual including all text under

subheadings therein before set

up or use of this product.

tO PREVENt

SERiOuS iNjuRY

FROm AccidENtAL

OPERAtiON: turn the Power

Switch of the tool to its “OFF”

position and unplug the tool

from its electrical outlet

before assembling or making

any adjustments to the tool.

Note: For additional information regarding

the parts listed in the following pages,

refer to the Assembly Diagram near

the end of this manual.

Assembly

NOtE: This should always be mounted to

a workbench before use.
Select an area with enough room to

fit the chosen dust collection system.

Select a workbench to mount the

Planer. Place the Planer on a

workbench able to support the weight

of the Planer and the wood stock

being planed. The orientation of the

Planer should enable the easy entry

and exit of long pieces of wood stock.
Using a pencil, mark through the

mounting holes of the Planer, onto

the workbench. Slide the Planer

aside and drill four 3/8 inch mounting

holes into the workbench.

Before

drilling, verify that there are no

utility wires or other obstructions

under the workbench.
Slide the Planer back over the

mounting holes in the workbench,

and secure the Planer to the

workbench with bolts, washers,

spring washers and nuts (not

included). Securely tighten.
Mount the height (thickness)

adjustment Handle (10) to the Right

Cap (11). See Figure A.

Figure A

Rev 10d

Crank

Handle (10)