General operating instructions – Harbor Freight Tools 95082 User Manual

Page 10

SKU 95082

For technical questions, please call 1-800-444-3353.

Page 10

allow access by children or pets to

prevent injury and distraction.
Route the power cord extension

along a safe path to reach the Planer

without creating a tripping hazard or

exposing the power cord to possible

damage.
There must not be hazardous

objects, such as utility lines or foreign

objects, that will present a hazard

while working.

general Operating instructions

Note: Before operating, remove foam

backing material from the Table (95).
Measure the thickness of the wood

stock to be planed.
Turn the Adjustment Knob (10) to set

the thickness of the cut, using the

Scale (103) as a guide. See Figure

D, above. Each complete turn of the

Knob equals about 1/16 inch, up or

down. Set the thickness to 1/16 inch

less than the thickness of the wood

stock. Make thin cuts at first, then

increase the cut depth as required,

up to 3/32 inch (maximum).
Place the end of the wood stock in

front of the Planer (wood grain facing

forward).

If the wood stock is long, support the

full length using a roller platform (not

supplied) or other device which is the

same height of the Planer Table (95).

5. Plug the Power Cord (157) into a 20

amp, 120V electrical outlet.

6. Lift the Switch Cover (162) and

push the Switch (161) to start. Allow

the planer to come up to full speed

before beginning a job.

7. When the motor is turning at full

Figure d

Crank

Handle (10)

Dust

Chute

(80)

Scale (103)

Table (95)

Switch Cover

(162)

Reset Button Circuit Breaker

(155)

Power Cord

(157)