Harman-Kardon AVR 630 - Manual (Page 2)

AVR 630 AUDIO/VIDEO RECEIVER
3 Introduction
4 Important Safety Information
4 Unpacking
5 Front-Panel Controls
8 Rear-Panel Connections
11 Main Remote Control Functions
15 Zone II Remote Control Functions
16 Installation and Connections
19 System Configuration
19 Speaker Placement
19 System Setup
20 Input Setup
21 Audio Setup
22 Surround Setup
23 Speaker Setup
25 Delay Settings
26 Output Level Adjustment
26 Using EzSet
27 Manual Output Level Adjustment
29 Operation
29 Basic Operation
29 Source Selection
29 6/8-Channel Direct Input
29 Volume and Tone Control
30 Surround Mode Selection
30 Digital Audio Playback
31 Surround Mode Chart
34 Tuner Operation
34 Tape Recording
34 Front-Panel Connections
35 Output Level Trim Adjustment
36 Advanced Features
36 Surround Amplifier Channel Assignment
36 Display Brightness
36 Turn-On Volume Level
37 Semi-OSD Settings
37 Full-OSD Time-Out Adjustment
38 Multiroom Operation
38 Multiroom Setup
38 Multiroom Operation
40 Configuring the Remote
40 Preprogrammed Code Entry
41 Automatic Code Entry
41 Learning Commands
42 Changing Devices
43 Macro Programming
45 Punch-Through Configuration
46 EzSet Configuration
47 Renaming
49 Resetting the Remote
50 Troubleshooting Guide
50 Processor Reset
51 Technical Specifications
See trademark acknowledgements on page 51.
2 TABLE OF CONTENTS
Typographical Conventions
In order to help you use this manual with the remote control, front-panel controls and rear-panel connections,
certain conventions have been used.
EXAMPLE – (bold type) indicates a specific remote control or front-panel button, or rear-panel
connection jack
EXAMPLE – (OCR type) indicates a message that is visible on-screen or on the front-panel
information display
EXAMPLE – (Synchro type) indicates a message that is displayed on the remote control’s LCD screen
1 – (number in a square) indicates a specific front-panel control
A – (letter in a square) indicates a front-panel control that is normally concealed behind the drop-down door
¡ – (number in a circle) indicates a rear-panel connection
a – (number in an oval) indicates a button or indicator on the remote
å – (letter in an oval) indicates a button on the Zone II remote