HONDA 08E02-SHJ-100B - Manual (Page 5)

© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38137-38714 (0801)
5 of 12
7517051E
7517072E
7517031E
NOTE: If another accessory is already plugged into the
6-pin connector, remove the dummy connector
from the 6-pin connector taped to the HFL
subharness. Plug the 6-pin connector from the
other accessory harness into the 6-pin
connector from the HFL subharness you just
unplugged and plug the HFL subharness into
the fuse box.
VEHICLE
HARNESS
VEHICLE
CLIP
GREEN
TAPE
WIRE
TIE
HFL
SUBHARNESS
VEHICLE
HARNESS
HFL
SUBHARNESS
4319060B
14. Route the HFL subharness to the left front pillar
trim opening.
FUSE BOX
HFL
SUBHARNESS
6-PIN
CONNECTOR
OTHER ACCESSORY
6-PIN CONNECTOR
DUMMY
CONNECTOR
16. Remove the vehicle bolt (discard) and install the
ground bolt with HFL subharness ground terminal
as shown.
17. Disconnect the vehicle harness 1-pin connector
and connect it to the HFL subharness 1-pin
connector.
VEHICLE
BOLT
(Discard.)
GROUND
BOLT
HFL SUBHARNESS
GROUND TERMINAL
FUSE
BOX
HOOD
OPENER
18. Connect the HFL subharness 1-pin connector to
the vehicle 1-pin connector.
19. Wrap the cut one half of the EPT sealer on the
HFL subharness connection part.
FUEL
OPENER
HFL SUBHARNESS
1-PIN CONNECTOR
VEHICLE
HARNESS 1-PIN
CONNECTOR
EPT
SEALER
HFL
SUBHARNESS
LEFT FRONT
PILLAR TRIM
OPENING
HFL SUBHARNESS
CONNECTION PART
EPT
SEALER
Cut in half.
15. Route the HFL subharness and secure the
harness to the vehicle harness with a wire tie
above the vehicle clip as shown.
www.collegehillshonda.com