Heath Zenith Wireless Strobe Chime 6144 - Manual

© 2008 HeathCo LLC 598-1143-02
Wireless Strobe
Chime
DANGER: Electric shock hazard. Do not open chime. No serviceable
components inside. If strobe fails to flash, replace chime.
This package includes (Style of push button and
chime may vary from illustration):
• Wireless strobe chime
• Wireless push button with battery
• Hardware pack
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screw-
driver (see Figure 1). See diagram inside push
button for correct battery orientation. Note:
If batteries are preinstalled, remove orange
battery tab.
2. Plug in wireless chime. To reduce the risk of
electrical shock, this equipment has a polar-
ized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet.
Do not attempt to bypass this safety feature.
3. Test range. Temporarily position push button
where you want it mounted. Press push button
to verify chime and push button work properly. If
chime does not sound, see Troubleshooting.
Figure 1
WARNING: To prevent possible SERI-
OUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.
Model 6144