Hitachi 50EX01B User Manual
Page 26
26
USING THE REMOTE TO CONTROL
CABLE BOX/SATELLITE FUNCTIONS
Operating the precoded function for your cable box.
This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system in
your cable box. (refer to page 27)
1.
Turn ON your cable box.
2.
Aim the remote control at the front of your cable box.
3.
Press the CABLE button on the remote to switch to cable mode.
4.
Hold down the CABLE button on the remote, enter the two digit preset code that matched your cable box as shown on page 27.
The remote will turn off your cable box when the correct two digit preset code is entered. When this occurs, the remote control is
programmed for your cable box. If the cable box does not turn off after five seconds, try another two digit preset code.
5.
The remote will now control your cable box.
*
If you wish to control a Satellite system or Audio equipment, you
must follow the remote programming procedure shown above.
You may use only the CABLE button to program these codes,
but note that this button may not be used for more than one
component.
NOTES:
1.
If your cable box cannot be operated after performing the
above procedures, your cable box code has not been
precoded into the remote.
2.
In the unlikely event that your cable box cannot be
operated after performing the above procedures, please
consult your cable box operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4.
If your cable box does not have a power function, the
remote will issue the CHANNEL UP function.
5.
The LST-CH button will act as your audio component s
ENTER button if required.
6.
The SLEEP button will act as your audio components
100 button if required.
ቢ
CABLE Button
This button allows the remote to control your cable box by
setting it to cable.
ባ
PRECODED CABLE Box Buttons
These buttons transmit the chosen precoded cable codes.
ቤ
EXCLUSIVE TV buttons
These buttons are for operating the TV.
ቢ
ቤ
ቤ
ባ
ባ
ቤ
ቤ
CLU-436UI
POWER
TV
CABLE
VCR
HELP
PIP CH
TV/VCR
PIP
SWAP
MOVE
FRZ
REC
STOP
PAUSE
LST-CH
EXIT
RECALL
MUTE
CH
VOL
1
2
3
4
5
6
7
8
9
0
MENU
SLEEP
INPUT
LIGHT