Hitachi 50EX01B - Manual (Page 21)

21
HOW TO USE THE REMOTE TO CONTROL YOUR TV
ቩ
EXIT/RECALL button
Press this button when no menu is displayed, when you want to check the channel being received, the picture source, or if it has
stereo (ST) or second audio (SAP), the time, CHANNEL ID, if SPECIAL EVENT REMINDER is set, and if the SLEEP timer is set.
When in MENU mode, this button will exit all On-Screen Displays.
ቪ
MENU, CURSOR buttons
All the On-Screen Display features can be set or adjusted by using these buttons.
The MENU button will start the On-Screen Display.
The CURSOR buttons will highlight functions or adjust and set different features.
ቫ
SLEEP button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add
15 minutes to this timer, up to a maximum of three hours. Once set, use RECALL to view time remaining. If the SLEEP button
is pressed while the timer is set, it will reset to the original condition.
ቭ
INPUT button
The INPUT button will select between antenna signal and the two sets of video input jacks each time the button is pressed. If the
Picture-in-Picture is on, the INPUT button will select between the two sets of video input jacks and antenna source when main chan-
nel is chosen with the PIP CH button. If the sub-picture is chosen, the INPUT button will select between the two sets of video input
jacks and the source COMPONENT VIDEO: Y-CBCR INPUT 2 source will be displayed as a blank PIP sub-picture.
ANT 10
ABCD
10:00PM
PIP ANT 12
STEREO
ST/SA
SLEEP 0:15
SLEEP
TIMER
Audio
Broadcast
Audio Selected Main Picture Source
CHANNEL ID
Time
Sub-Picture
Source
PIP
SPECIAL
EVENT
REMINDER
When an S-VIDEO
Input is connected to
VIDEO: 1.
When a COMPONENT
VIDEO: Y-CBCR Input is
connected to VIDEO: 2.
S - IN: 1
Y - CBCR: 2
ANT A 28 S - IN: 1 Y - CBCR: 2
INPUT
INPUT
INPUT