Lift preparation - al560 cont'd, Al 560, Lift preparation – Harmar Mobility AL500 User Manual

Page 14

LIFT PREPARATION

HOLD DOWN ARM HEIGHT ADJUSTMENT

AL 560

LOOSEN BOLTS

TIGHTEN BOLTS

HIGHER ARM SETTINGS
CAN BE ACHIEVED BY
REMOVING TOP
SHAFT COLLAR,
RETRACTING
T HANDLE AND
RE-INSERTING ARM
FROM ABOVE.

THIS METHOD ALLOWS THE RED “T” HANDLE
TO REMAIN ON THE SAME SIDE AS THE KEY
AND TOGGLE SWITCHES.

DRIVE CHAIR ON PLATFORM

PULL RED “T” HANDLE
ROTATE ARM TO OVER SEAT

RAISE PLATFORM
UNTIL CLUTCH

DROP ARM
TO CONTACT SEAT

DROP ARM AGAIN
TO CONTACT SEAT

LOWER LIFT
APPROXIMATELY
2-3 INCHES

REPLACE
SHAFT
COLLAR

VERIFY ARM PRODUCES
ENOUGH PRESSURE ON
SEAT TO FIRMLY HOLD

POWER CHAIR TO PLATFORM
SEAT SHOULD BE SOMEWHAT
DEFORMED BY ARM.