Hotpoint RLS80 - Manual (Page 16)

CLEANING &
MAINTENANCE
Door Reversal
16
Note : You may require assistance to do this:
25. Place the top hinge onto the door, slide the door onto the
bottom hinge pin and support the door whilst screwing the top
hinge bracket into position.
Ensure that the top hinge bracket is positioned correctly.
26. Adjust the front feet (see ‘Levelling’ SAFETY & INSTALLATION section).
27. Fit the bottom hinge covers (see ‘Hinge Covers’ in the SAFETY &
INSTALLATION section).
Note : Let the appliance stand upright in it’s final location for at least 15
minutes before plugging in and switching on the electricity supply.
Door Handle Reversal:
Note: This MUST be completed with the door OFF the product.
18. Remove the hole plugs from the right hand side of the door.
19. Unscrew the handle cover retaining screws and remove the covers.
20. Unscrew the handle fixing screws and carefully remove the handle from the
door.
WARNING: Take care not to dislodge the internal mechanism when
removing the handle from the door.
21. Turn the handle vertically, top to bottom and place it against the right hand
side, positioning both blades in the seal pocket.
22. Secure the handle in place with the original fixing screws.
23. Fit the handle covers in position, using the original retaining screws.
24. Use the hole plugs removed from the right hand side to fill holes on the left.
door stop
seal stop
14. With the door furniture removed carefully lie the door
onto its interior lining.
We recommend that you lie the door onto a suitable
protective material (ie. the original packaging).
15. Remove the seal stop on the top left of the door:
Remove the fixing screw, then using a thin blunt
instrument, lever the seal stop off the door.
Repeat to remove the seal stop on the bottom left.
16. Use a screwdriver to remove the door stop from the
bottom right of the door and refit on the bottom
left.
17. Refit the seal stops, one top right the other bottom right. Push into position
and secure with fixing screw.