Harbor Freight Tools Chicago Electric LED Work Light 66308 - Manual (Page 6)

SKU 66308 For technical questions, please call 1-800-444-3353. Page 6
SpeciFicAtionS
Electrical Requirements 110 V~ / 60 Hz / 4.4 W
Light Strength 270 Lumens
unpAcking
When unpacking, make sure that
the item is intact and undamaged. If any
parts are missing or broken, please call
Harbor Freight Tools at the number shown
on the cover of this manual as soon as
possible.
initiAl Set up
inStructionS
read the entire importAnt
SAFetY inFormAtion
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
to preVent
SeriouS injurY
From AccidentAl
operAtion:
unplug the light from the
electrical outlet before
assembly.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Slide the Base (2) into the bottom of
1.
the Lamp Assembly (1).
Secure with the Knob (3).
2.
operAting inStructionS
read the entire importAnt
SAFetY inFormAtion
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Position the LED work light near the 1.
work. Loosen Knob (3) and adjust
Lamp Assembly (1) to direct the light
beam. Tighten the Knob (3).
Plug the Light into a grounded 110V
2.
electrical outlet.
To prevent accidents, disconnect the
3.
power supply after use. Clean, then
store the tool indoors out of children’s
reach.
reV 09b