Harbor Freight Tools 98870 - Manual (Page 6)

Page 6- SKU: 98870
Arc Welder ASSeMbly
installing the Handle
Locate the HANDLE (7) and SCREW (8).
Slide the HANDLE (7) onto the top of the
CASE (6), indexing the tabs on the underside
of the HANDLE onto the slots on top of the
CASE, as indicated by lines (A) in Figure 1.
Insert the SCREW (8) through the HANDLE
(7), as shown in Figure 1, and tighten secure-
ly with a screwdriver.
installing the ground clamp
WArning! Be sure to connect the Ground Clamp to the GROUND WIRE (4) ONLY. Check
the Parts Diagram to be sure you have selected the correct wire.
Figure 2.
Ground Clamp
Installation
Locate the Ground Clamp which is included in your welder kit, see Figure , step 1.
Slide the Handle Grip off the Ground Clamp, exposing the Wire Attachment area .
Slide the Handle Grip over the end of the GROUND WIRE (4), see Figure , Step .
Attach the GROUND WIRE (4) to the Ground Clamp, using a Bolt, Nut and Washer,
as shown in Figure , Step 3.
With the GROUND WIRE secure, slide the Handle Grip over the Ground Clamp,
covering the attachment of the Ground Wire to the Ground Clamp.
Your assembled Ground Clamp will look like Figure , Step 5.
WArning! Welder produces powerful electric currents. Operator must remain insulated
from this current. Never use if any insulating Handle Grip is not in good repair.
1.
.
3.
1.
.
3.
4.
5.
Figure 1. Handle Installation Figure 1. Handle Installation