Assembly, Assembling other guards and cutting equipment – Husqvarna 240L User Manual

Page 13

English –

ASSEMBLY

Assembling other guards and
cutting equipment

Assembling and dismantling the
two-part shaft (227LD)

• Fit the guard (A)

intended for use with
the trimmer head.
Secure using four bolts
(L) and the support plate
(M) as shown in the
diagram.

• Fit the disc drive (B) on

the output axle.

• Turn the blade axle until

one of the disc drive’s
holes aligns with the
corresponding hole in
the gear housing.

• Insert the locking pin

• Screw on the trimmer

head (H) in the
direction of rotation.

• Dismantling takes place

in the reverse order.

Assembling:

• Make sure the handle is

loose.

• Guide the cut-out on the

lower section of the shaft
into the coupling‘s
locking plate on the
upper section of the
shaft. The sections are
then locked together.

• Tighten the handle.

Dismantling

• Undo the handle (at least

three turns).

• Press the handle towards

the coupling.

• Carefully twist the lower

section out of the lock.

• Hold both parts of the

shaft and pull out the
lower section from the
coupling.

This manual is related to the following products: