HP M415 - Manual (Page 127)

127 Troubleshooting and Support
NOT ENOUGH
LIGHT FOR FAST
SHOT
The light is low
and the image is
likely to be noisy
due to the small
aperture setting
used in Fast Shot
mode.
Add light to the scene.
(Flash is set to Flash Off in
Fast Shot mode.)
(camera shake
warning)
The light is low
and the image is
likely to be blurry
due to the long
exposure
required.
Use the flash (see
page 40), set the camera
on a stable surface, or use
a tripod.
ERROR SAVING
IMAGE
or
ERROR SAVING
VIDEO
The optional
memory card that
is installed was
half-locked or
was removed
before the
camera finished
writing to the
card.
• Always wait until the
Memory light stops
blinking before
removing the memory
card from the camera.
• With the camera
turned off, remove the
memory card and
check to see if the
locking tab on the
edge of the card is fully
in the unlocked
position.
Message Possible Cause Solution