Harbor Freight Tools ROTARY HAMMER 94944 - Manual (Page 11)

SKU 94944 PAGE 11
How to turn on the Rotary Hammer
1. To turn on the Rotary Hammer squeeze the Switch (107) shown below in Figure
3. There is a latch on the upper part of the switch that locks the switch on.
How to attach the chisels
WARNING: Always make sure this tool is not plugged in before changing the bits.
1. Slide the Bits into the Rotary Hammer with the flat cut-out side facing the Rod (19)
as shown in Figure 2.
2. Pull out the Rod (19) while you insert the Bit. See Figure 1. The two bits both have
a flat space on the shaft that must be turned horizontally when it is inserted. See
Figure 2. Turn the Rod (19) clockwise 180° to lock the Bit into place. The Bit should
move in and out after it is locked but should not come out.
Flat area of Bit
Rod (19)
Figure 3
Figure 2 Figure 1
Switch (107)
OPERATING INSTRUCTIONS